Microsoft word - oilfield_tank_lining

Endura Manufacturing Co. Ltd. TEL 1-800-661-9930 Endura’s one-day Oilfield Tank Lining System. This product has been tested and is recommended exclusively for 200 bbl and 400 bbl oilfield storage tanks. Used unde r normal operating conditions this coating system will provide excellent long term performance. Suitability
Product Features
Endura Oilfield Tank Lining system is for use in 200 and 400 bbl tanks used storage. Service temperature dry: 200ºC/360ºF. Surface Preparation
It is recommended that all steel and other ferrous surfaces be sandblasted or mechanical y sanded with 80 grit sand paper. Surface must be cleaned all contaminants Mixing Ratio
1 part by volume of component B [FUB0108] The recommended temperature when mixed is 20-25°C (68-77°F). Theoretical Solids
Content:
Environmental Conditions
For optimum coating performance product, substrate and ambient temper Shelf Life*
between 20°C-25°C* (68°F-77°F). To prevent condensation during applicati surface temperature must be 3°C (5°F) or more above the dew point at all *for use outside this range please contact your Endura representative. Spraying Viscosity
Pot Life of Mixed
Product:
Spray Gun Setup
Endura Manufacturing Co. Ltd. is committed to ongoing product development to provide the best products. New materials, production methods and design refinements are introduced into existing products without notice. For this reason, any current Endura product may differ in some respect from its published description. It is always warranted to equal or exceed the original design specifications, unless otherwise stated. Endura Manufacturing Co. Ltd. TEL 1-800-661-9930 Oilfield Tank Lining Endura’s one-day Oilfield Tank Lining System. This product has been tested and is recommended exclusively for 200 bbl and 400 bbl oilfield storage tanks. Used under normal operating conditions this coating system will provide excellent long term performance. Application Method
Product Features

- Tank should be well ventilated during and after application. Recommended Film Build Thickness and Cover Rate
Endura Oilfield Tank Lining Coating has a recommended film build thickness of 8.0-15.0 Theoretical coverage at 1.0 mil (25 microns) DFT: 1056 ft² per gallon @ 100% transfer efficiency. (Approximately 15 gallons per 400 bbl tank). Drying Time*

Theoretical Solids
Content:
* Subject to ambient conditions and good air movement. Shelf Life*
Component A: (1) year
Specifications
Pot Life of Mixed
Product:
For VOC amounts please refer to the product MSDS
Endura high strength gun wash, Endura epoxy reducer or Endura EX-2C thinner.
All applicators will require certification and training. Training will be provided by an authorized representative of Endura Manufacturing Co. Ltd. This coating system is NOT recommended for acid tanks (HcL) which require product specific linings. Endura Manufacturing Co. Ltd. is committed to ongoing product development to provide the best products. New materials, production methods and design refinements are introduced into existing products without notice. For this reason, any current Endura product may differ in some respect from its published description. It is always warranted to equal or exceed the original design specifications, unless otherwise stated.

Source: http://www.centralalbertapaintsupply.ca/TDS/FromFred/endura%20tds/oilfield_tank_lining.pdf